E-mail : info@mayer.cn

The processing of cold drawn stainless steel three-way and the structure of the regulating valve

by:Mayer     2021-08-22
Cold drawn stainless steel tees are a type of stainless steel tees. There is no unified model for stainless steel tees. In principle, common stainless steel tees and reduced diameter combinations can also be used where cold drawn stainless steel tees are commonly used. For drainage pipes Normally, stainless steel tees are not used. Even if the connected branch pipe is smaller than the main pipe, the diameter can only be changed by filling the core. As for the elbow, the typical requirement is that the pipe larger than DN100 can only be turned 90 Use two 45 elbows, and the purpose of the placement of cold drawn stainless steel tees can not be reversed, and so on. The processing method of cold drawn stainless steel tees is: mark the place where the pipe is to be processed with different diameter stainless steel tees Mark the flag, and punch through the mark mark. The cold drawn stainless steel tee processing method conforms to the cold drawn stainless steel tee processing on the pipes of different specifications. Its special processing equipment is equipped with a rough structure, low cost, and cold manufacturing. Pulling stainless steel tee does not require other injection molding machines and injection molds, which can reduce the production cost of such pipe fittings and advance production compliance. For water supply pipes, pipe fittings selection, if it is based on the size of the pipe marked on the drawing, see if there is any Select response pipe fittings such as variable diameter, corner, branch pipe, etc.    cold drawn stainless steel three-way regulating valve has two structural forms: confluence and divergence. The spool structure adopts a cylindrical thin-walled window and is guided by the side of the spool. In some cases, the stainless steel three-way valve can be replaced by two two-way valves and a stainless steel three-way. Phase adjuster, can also be used for roughly proportioning adjuster. When the nominal diameter and pressure difference are small, the confluence valve can be used in shunting occasions and can be operated by AC, but it cannot be operated in shunt occasions where the nominal diameter is larger than 80mm and the pressure difference is larger.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...